Lutterloh Pdf
Lutterloh Patterns Download
Vintage Lutterloh Patterns
Free Lutterloh Patterns Pdf
Free Lutterloh Pattern Sheets

The Golden Rule – Lutterloh pattern making system is amazing simple!

The Lutterloh system is a book of 1/4 scale patterns that need to be enlarged to be used. The method of enlargement is the radial projection method. You need to tape the scaled pattern near the bottom left corner of a large sheet of paper. The Golden Rule from Lutterloh-System® gives you thousands of beautiful sewing patterns, dress patterns and knitting patterns! Skip to content. Sewing patterns for you! Info or questions? Phone USA (239) 935 5119 UK 020 3290 5552. Login; Cart / $ 0.00 0.

How to make a perfect fitting pattern in minutes !

You only need two measurements to make a perfect made to measure pattern in just minutes.

The Lutterloh System “The Golden Rule” have a little patterns to work with, and a special tape-measure with a sizing scale. To start you choose the pattern you want to make to your exactly size.

Choose your model and you have the corresponding pattern in the back of each page. In the complete kit you have 280 models to chosse!

Take your measurements: You only need bust and hip measurement.

1. Take your bust measurement.

Bust contourn for all pieces corresponding to upper part of the body including the waist like front and back of a blouse, sleeves, collars, etc.Lift the tape over the shoulder blades, under the arms and over the fullest part of the bust. Jfk reloaded mac free.

2. Take your hip measurement.

Hip contourn to make all pieces corresponding to the lower part of the body like pants, skirts, or the lower part of a dress. Measure over fullest part of the hip and just below the fullest part of the stomach.

3. Tape the little pattern on the paper.

Centering the pattern in the paper, fasten the chosen pattern by applying scotch tape at two corners.

4. Inserting the pin into the scale.

We find the measurement (bust or hip) in the sizing scale. Every size (the numbers in black and red) has a line with a small hole. Push the special pin through the hole that denotes your bust or hip measurement.

5. Fix the measure onto the pattern

Carefully fix the pin, with the measurement in the scale, on the center of the cross. Every pattern has a cross. In some small pieces like collars, the cross is outside the pattern, an arrow in the cross toward the pattern to wich its belongs. Use a small cardboard underneat to fix the pin, to avoid damage to your table.

6. Making dots

Now we can rotate freely the tape in any direction. Align the edge of the tape to any line, making sure than the tape is in the same direction of the line, and make a dot in the cm number in the tape which match the number in the line.

Make the dots on the same side of the tape, where the line and number is shown on the pattern diagram.

7. All dots

Use the bust measurement to make all dots above the waist, including the waist. Adobe after effects 2020 mac. Tower 2.2.2.

Change the pin to the hip measurement and draw all dots below the waist.

Lutterloh Pdf

8. Connecting the dots

Once we have transferred all dots, all we need to do is connect them, coping all the lines from the little pattern with our rulers, also the darts and symbols.

Important: Remove the pattern diagram and mark the pin hole. This is where the pattern is adjusted for the individual body length.

9. Cutting the pattern and check it

The pattern corresponds to your fit, your can adjust the length to suit your individual taste. Pin the darts, according to the shape and size of your figure. Always check pattern for correct fit, before cutting the fabric.